manual:subwaysim:map_construction:prepare_map
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| manual:subwaysim:map_construction:prepare_map [2026/01/14 15:05] – dcs | manual:subwaysim:map_construction:prepare_map [2026/01/14 15:42] (current) – [Configuring Player Spawn Settings] dcs | ||
|---|---|---|---|
| Line 278: | Line 278: | ||
| Drag **BP_PlayerSpawn** into your level and place it at the desired location. | Drag **BP_PlayerSpawn** into your level and place it at the desired location. | ||
| Rotate the actor so that the **arrow points in the direction the player should face** after spawning. | Rotate the actor so that the **arrow points in the direction the player should face** after spawning. | ||
| + | |||
| + | {{: | ||
| Typically, player spawns are placed: | Typically, player spawns are placed: | ||
| Line 299: | Line 301: | ||
| Using this setup, you can control **which platforms can be used as takeover points in career mode**. | Using this setup, you can control **which platforms can be used as takeover points in career mode**. | ||
| + | |||
| + | {{: | ||
| ==== Important Note ==== | ==== Important Note ==== | ||
| Line 315: | Line 319: | ||
| Do not add career logic here — only place and configure the spawn actors. | Do not add career logic here — only place and configure the spawn actors. | ||
| - | ==== Finalizing Station Setup ==== | + | ---- |
| + | |||
| + | ===== Finalizing Station Setup ===== | ||
| Configure all stations until the station layout matches the intended design. | Configure all stations until the station layout matches the intended design. | ||
manual/subwaysim/map_construction/prepare_map.1768399508.txt.gz · Last modified: by dcs